CJ750 toolbox
Clutch plate and flywheel removal by George Baker
The six 8x1x15mm bevel headed screws holding the pressure plate are “staked” from the factory, but can be easily removed with an impact wrench. Caution! The pressure plate is spring loaded. Do not remove all screws at once.
Remove two screws adjacent from each other. In their place, screw in two 8x1x50mm bolts with nuts and washers. Now remove the four other screws. Then release pressure plate by slowly backing nuts off bolts.
Clutch plate and springs can now be removed. (Note order and direction.)
Flatten lock tab, then using a 36mm socket and impact wrench, remove the special 18x1.50x28mm flywheel bolt.