CJ750 toolbox Inserting a clutch shaft by Dan Cason
Pushing the shaft into the case with the tube from a radio antenna cut up. The tube slips on the shaft.
Jiggle this up and down and twist it till you feel the square end of the clutch shaft pop into place. Don't forget to put a couple drops of oil on the felt wiper before it goes in. .
The push pin slid into the tube and pressing against the clutch shaft.
Put a drop of lube oil on each part when installing.
The pressure side of the thrust bearing goes next.
The thrust bearing. Don't forget a drop or two of oil here.
The throw-out bearing plunger. The clutch lever rides in this groove. Not all of these plungers are made the same. Some have the O rings installed in the trans case and the plunger is smooth.